Installing Hardware - National Instruments 7831R Getting Started

Installing NI-RIO Device Drivers

Installing Hardware

Note You must install the NI-RIO device drivers before installing the NI 7831R device.
Unpacking
Caution Never touch the exposed pins of connectors.
Getting Started with the NI 7831R
Complete the following steps to install the NI-RIO device drivers that are
included with the NI 7831R device. If you are using LabVIEW, complete
the installation instructions in the
Real-Time Module for ETS, and the LabVIEW FPGA Module
before installing the NI-RIO device drivers.
1. Run
setup.exe
instructions.
2. Follow the onscreen instructions until the Feature Tree window
appears.
3. In the Feature Tree window, select the components to install. You must
install NI-VISA, NI-RIO, and NI Measurement & Automation
Explorer (MAX).
4. Follow the onscreen instructions to complete the driver installation.
5. Reboot your computer.
This section describes how to unpack and install the PXI-7831R and the
PCI-7831R devices.
The NI 7831R device ships in an antistatic package to prevent electrostatic
discharge from damaging device components. To prevent such damage
when handling the device, take the following precautions:
• Ground yourself using a grounding strap or by holding a grounded
object, such as your computer chassis.
• Touch the antistatic package to a metal part of the computer chassis
before removing the devices from the package.
Remove the devices from the package and inspect the devices for loose
components or any other sign of damage. Notify NI if the devices appear
damaged in any way. Do not install damaged devices into the computer.
Store the NI 7831R in the antistatic envelope when not in use.
Installing LabVIEW, the LabVIEW
from the NI-RIO CD and follow the setup
6
section
ni.com