Removing Rtx Support - National Instruments 7831R Getting Started

Removing RTX Support

© National Instruments Corporation
Windows finishes installing the software, click Finish. The
NI PCI-7831R appears under RTX Drivers as NI-7831R RTX
Supported.
8. In the Device Manager window, select View»Resources by
connection.
9. In the Device Manager window, expand Interrupt Request (IRQ).
Make sure that the NI PCI-7831R is not sharing an IRQ with any other
devices. Refer to the Venturcom RTX Runtime Help for information
about modifying a PCI device.
10. Reboot your computer.
11. Select Start»Run. In the Run window, enter
and click OK.
The PCI-7831R now supports RTX. When you launch LabVIEW, the
PCI-7831R appears in the LabVIEW Execution Target menu as FPGA
Device (PCI-7831R) visa://localhost::RTRTX::0/RIO0::INSTR.
Complete the following steps to remove RTX support from the PCI-7831R.
1. Close all NI software.
2. Select Start»Program Files»Venturcom RTX»RTX»RTX
Properties.
3. On the Plug and Play tab, right-click NI-7831R and select Remove
RTX INF Support.
4. Click Apply. RTX Properties returns a Warning dialog box. Click OK.
5. In the RTX Properties window, click OK.
6. Right-click My Computer and select Properties.
7. Select the Hardware tab and click Device Manager.
8. For Windows XP, expand Rtx Drivers, right-click NI-7831R RTX
Supported and select Update Driver.
You have removed RTX support for the PCI-7831R.
9
net start nirtrtx
Getting Started with the NI 7831R