Dsc Programming - Blaupunkt SYDNEY RCM 128 Operating Instructions Manual

Proceed as described above for all of the
CDs/magazines for which the entered name
is to be maintained.
• After having updated the last maga-
zine, press .
To quit the function,
• press DSC.
The system has saved the name informa-
tion for all of the CDs which were inserted.
For all other discs the CD names have been
deleted.
50

DSC programming

DSC (Direct Software Control) allows you
to customise certain programmable, basic
settings to suit your personal needs and
preferences and then store them.
The basic settings for this audio equipment
were made at the factory.
In the following you can find an overview of
these settings, so that you can always reset
to these if desired.
If you wish to alter any of the programming,
• press DSC.
Use the rocker switch and the
select and adjust the functions described in
the following. The display will show you the
adjusted condition.
/ Select function
<< >> Adjust/recall value
CDC NAME Only available for CD
changer playback (optional).
Use this function to name
your CDs. (See "Entering
CD names").
LOUDNESS Loudness - When listening
at a low level, the Loudness
function creates a more nat-
ural sound by boosting the
low frequency range.
LOUD 1 - Low boost
button to
LOUD 6 - Max. boost
TA VOL To adjust the traffic an-
nouncement and warning
beep volume from between
0 to 63.
The message will then come
through at this volume, if the
standard volume is lower.
Should the standard volume
be higher than the TA VOL
level, then the traffic report
will be played slightly louder
than the standard volume.