Dsc Programming - Blaupunkt LUGANO RCR 87 Operating Instructions Manual

Radio / cassette
Hide thumbs Also See for LUGANO RCR 87:
Table of Contents

Advertisement

DSC programming

DSC (Direct Software Control) allows you
to customise certain programmable, basic
settings to suit your personal needs and
preferences and then store them.
The basic settings for this audio equipment
were made at the factory.
In the following you can find an overview of
these settings, so that you can always reset
to these if desired.
If you wish to alter any of the programming,
press SC/SRC to select the relevant
operating mode (e.g. select the cas-
sette mode if you wish to turn the
Radio Monitor on or off).
press DSC.
Use the rocker switch to select and adjust
the functions described in the following. The
display will show you the adjusted condition.
/
Select function
<< >>
Adjust/recall value
32
REG ON/OFF REG ON – regional function
is switched on.
REG OFF – regional func-
tion is switched off.
Refer to "Radio operation
with RDS / REG - regional
programme".
RM ON / OFF (Radio Monitor)
(RM ON/OFF appears only
in the cassette mode)
Allows you to listen to the
radio during fast winding of
the tape.
RM ON – Radio playback
activated
RM OFF – Function deacti-
vated
VOL FIX
Use this function to select
the volume at which the ra-
dio is set when it is switched
on. Adjust the desired vol-
ume level with << >>. If
"VOL 0" is set, the system
will come on with the vol-
ume selected before switch-
ing it off.
BEEP
Acknowledgement tone for
all of the functions which re-
quire a button to be pressed
for more than 1 second.
The volume can be set from
between 0 to 9. (0 = off)
TA VOL
To adjust the traffic an-
nouncement and beep tone
volume from between 0 to
63.
The message will then come
through at this volume, if the
volume set for the program
is lower.
If the program volume is
higher than the TA VOL lev-
el, the traffic report will be
played slightly louder.
LOUDNESS When the system is played
at a low volume level, the
Loudness function creates a
more natural sound by
boosting the low frequency
range.
LOUD 1 - Low boost
LOUD 6 - Max. boost

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Milano rcr 127San marino rcr 127

Table of Contents