Tape Operation; Inserting A Tape; Tape Care; Dsc Programming - Blaupunkt RCC 45 Operating Instructions Manual

Tape operation

Inserting a tape

• Turn on the set.
• Insert a tape.
Insert the tape with the empty reel first, the
open side facing to the right.
FF = Fast Forward
To start/stop: Press button slightly.
= To eject the tape.
Press button firmly.
When listening to a cassette, the display
shows "TAPE".
At the end of the tape side, the radio will come
on automatically.

Tape care

To avoid possible problems, you should not
use cassette tapes longer than 60 or 90
minutes (C60/C90). Store your tapes in a
cool place away from dirt, dust and tempera-
tures exceeding 50 ° Celsius. Allow very cold
tapes to warm up before playing them in
order to avoid uneven tape transport. After
approximately 100 hours of use, tape run
problems and sound distortions caused by
dust particles adhering to the rubber roller
and the audio head may be produced.
Use a head cleaning tape to remove normal
dirt build-up. For tougher cases, use a cotton
swab (Q-Tip) soaked with alcohol. Do not
attempt to clean by inserting a hard object
into the player!

DSC programming

DSC (Direct Software Control) allows you to
customise certain programmable, basic set-
tings to suit your personal needs and prefe-
rences and then store them.
The basic settings for this audio equipment
were made at the factory. In the following you
can find an overview of these settings, so that
you can always reset to these if desired.
If you wish to alter any of the programming,
• press DSC.
Use the rocker switch to select and adjust the
functions described in the following. The dis-
play shows you the adjusted condition.
/ Select function
Adjust value –
Adjust value +
23