3
WORK
3.4
Installing the battery
3.5
Recharging the battery
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep the battery away from sparks or open flames. Charge only in well-ventilated areas.
–
In the event of skin contact, rinse with large amounts of water. If battery acid gets in the eyes, rinse with water for at least
15 minutes and contact a physician.
Warning
Environmental hazard The battery contains elements that are harmful to the environment.
–
Do not discard batteries with the household trash. Dispose of a defective battery in an environmentally compatible manner.
Give the battery to your KTM dealer or to a recycling center that accepts used batteries.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
–
Disconnect negative cable
–
Disconnect the positive (plus) cable
–
Take the battery
Info
Never operate the motorcycle with a discharged battery or without a battery.
In both cases, electrical components and safety equipment can be dam-
aged. The vehicle is then no longer safe to ride.
B00192-10
Main work
–
Position the battery in the battery compartment.
–
Connect positive cable
–
Connect negative cable
B00192-11
–
Fold cover
–
Mount and tighten screws
–
Attach the connector to the start relay.
–
Position the wiring harness and fasten it with cable binders.
B00191-11
Finishing work
–
Install the front spoiler. (
–
Set the clock. (
of the battery.
3
4
out of the battery compartment.
5
.
1
.
2
up.
3
.
4
p. 9)
p. 11)
of the battery.
7