Setting The Clock - KTM 990 Super Duke FR Setup Instructions

3 WORK
3.11 Setting kilometers or miles
Info
If you change the unit, the value ODO is retained and converted accordingly.
Making the setting according to the country.
3.12

Setting the clock

3.13 Installing the front spoiler
1 0 0 0 1
2 2
–
Press the SET button
The low fuel warning lamp
returns to the previous display mode.
Info
If the SET button
approx. 3 minutes.
400970-12
Condition
The motorcycle is stationary.
–
Switch on the ignition by turning the ignition key to the ON
–
Press the MODE button repeatedly until the ODO mode is active.
–
Keep the MODE button pressed until the display mode changes from km/h to mph or
from mph to km/h.
400893-10
Condition
The motorcycle is stationary.
–
Switch on the ignition by turning the ignition key to the ON
–
Press the MODE button repeatedly until the ODO mode is active.
–
Keep the MODE button and the SET button pressed simultaneously.
The time display begins to flash.
–
Press the MODE button to set the hour.
–
Press the SET button to set the minute.
–
Keep the MODE button and the SET button pressed simultaneously.
The time is set.
400893-12
–
Position the front spoiler.
–
Mount and tighten screws
Guideline
Screw, front spoiler
1 1
–
Fully tighten screws
B00245-10
for two seconds.
2
goes out. TRIP F is set to 0.0 and the display
1
is not pressed, the value is automatically reset after
2
with the washer.
1
M6 10 Nm
(7.4 lbf ft)
.
2
11
position.
position.
Loctite ® 243™