Engine - Graco LineLazer IV 200HS Repair And Parts List

Removal
1. Relieve pressure; page 7.
2. Remove throttle cable from engine.
3. Do Fan Belt, Removal; page 18.
4. Loosen hand nut (241). Swing bracket (30) out.
5. Fig. 6. Disconnect blue, brown and orange leads
from engine (185).
6. Remove engine and rocker plate (87c) from spray-
er.
7. Remove four screws (189), washers (114), wash-
ers (170) and nuts (118) and remove rocker plate,
dampeners (59) and washers (114) from engine.
NOTE: All service to the engine must be
performed by an authorized HONDA dealer.
ti6520a
Fig. 6

Engine

114
241
30
Installation
1. Install rocker plate (87c), dampeners (59) and
washers (170), washers (114) on engine (185)
with four screws (189), washers (170) and nuts
(118); torque to 20 ft-lb (27.1 N·m).
2. Install engine and rocker plate (87c) on sprayer.
3. Connect blue, brown and orange leads.
4. Do Fan Belt, Installation; page 18.
5. Swing motor retainer bracket (30) in. Tighten hand
nut (241).
GREY
BROWN
ORANGE
BLUE
118
170
GREEN
59
87c
114
189
311021 19