Toyota Expert EPS9000 Instruction Manual page 97

No. Error Message
10
RAM CHECK Memory check error
ERROR
11
INTERNAL COM Internal
ERROR communication error
12 INTERNAL Internal connection
CONNECT ERR error
13 THERMAL High temperature
ERROR error
14 LIMIT ERROR Limit error
15
BAD NUMBER Wrong design
number
16 INSERT DISK Floppy disk was not
inserted.
17
CANNOT READ Floppy disk read error 1) When reading the
DISK
18 FILE NOT FOUND Designated file could
not be found
Description
1) Memory error
1) Communication error in
the embroidery machine
(ESP9000)
1) Connection error in the
embroidery machine
(ESP9000)
1) Temperature in the
embroidery machine
(ESP9000) exceeded
the allowable limit.
1) The embroidery hoop
has reached the travel
limit in the X- or Y-axis
direction.
1) When reading the
design data from the
external device, a wrong
design data number was
designated.
1) When reading the
design data from the
floppy disk drive, floppy
disk was not set in the
floppy disk drive.
design data from the
floppy disk drive, reading
of the set floppy disk
was not possible.
1) When reading the
design data from the
floppy disk drive, the
designated data was not
found in the set floppy
disk.
97
Cause Corrective Action
• Please contact your local
TOYOTA dealer.
• If this error occurs
frequently, contact your
local TOYOTA dealer.
• Please contact your local
TOYOTA dealer.
• Keep the power supply
OFF for more than 30
minutes.
• Set the start point of
design correctly.
• Designate a correct
design data number.
• Insert the floppy disk in
the floppy disk drive.
• Set the floppy disk
(Toyota, Tajima, or ZSK
format) correctly.
The floppy disk or the
floppy disk drive may be
faulty.
• Write the desired data to
the floppy disk using the
external device.
Refer
to




29
62, 64
62

