Carrying; Installation - Toyota Expert EPS9000 Instruction Manual

CARRYING

As shown in the illustration below, hold the machine at the positions indicated in the label by two or more per-
sons to carry the machine.

INSTALLATION

Place the embroidery machine on a rugged base so that the table will be level.
At this time, make sure to place attached vibration-preventive rubbers (H)
under the adjuster foot (1). The rubbers will effectively prevent the machine
from moving on the table or vibrating.
If the machine is not stable or it is not level, adjust the level of
the machine after loosening the nut (2) (4 places) of the adjuster
foot (1). After adjusting the machine level, tighten the nut (2) to
lock the adjuster foot.
Vibration-preventive rubber (H)
Machine holding position
(indicated in the label)
Table top face
Vibration-preventive rubber (H)
Nut (2)
15
! WARNING ! ATTENTION
CARRYING
Carry the machine with Il faut être au moins 2personnes
at least two people. pour porter la machine.
DO NOT hold it by parts Ne pas tenir la machine par
other than those specified. une autre partie que celle
Dropping may cause bodily indiquées.
injury and will damage Une chute peut vous blesser
the machine. et endommager la machine.
Machine holding position
(indicated in the label)
Base (must be level)
Adjuster foot (1)