Adjusting The Volume; Muting The Device; Operation With Telephone - Blaupunkt MEMPHIS MP66 7 646 520 310 Operating And Installation Instructions

Radio cd sd usb mp3 wma
Table of Contents

Advertisement

General functions
Connect the USB medium to
the USB cable that is routed
from the rear side of the de-
vice.
The USB medium can now be
selected as audio source.
For the device to recognise the
USB medium, it must be specifi ed
as mass storage device and for-
matted using the FAT16 or FAT32
fi le system and contain MP3 or
WMA fi les. Blaupunkt cannot
guarantee the proper function-
ing of all USB media available on
the market. If extensive fi les are
stored on your USB 2.0 medium,
the fi le search (see page 100) can
be slow.

Adjusting the volume

WARNING!
Danger from excessive
volume!
Excessive volume can damage
your hearing and you may fail to
hear acoustic warning signals!
Do not change the volume
while the device changes the
CD in the CD changer or the
audio source.
Always set the device to a mod-
erate volume.
76
Turn the volume control
The current volume is shown
on the display and used for all
audio sources.
Note:
To preset the volume of traffi c
announcements (Traf), a con-
nected telephone (Phone) and
the signal tone (Beep), see
page 115 and 116.

Muting the device

The device can be muted as fol-
lows:
Briefl y press the On/Off but-
4
ton
.
The display shows "MUTE".
To cancel the mute function:
Briefl y press the On/Off but-
4
ton
again or turn the volume
5
control
.

Operation with telephone

If a hands-free system is installed
in your vehicle or your cell phone
is connected to the device via a
Bluetooth adapter, the device re-
sponds as follows to incoming or
outgoing telephone calls:
The voice of the person calling
you is played back via the loud-
speakers of the vehicle,
5
.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Memphis mp66

Table of Contents