Indicators And Display Messages - Toshiba e-STUDIO161 Operator's Manual

INDICATORS AND DISPLAY
MESSAGES
If one of the following indicators lights up or one of the following messages appears in the display, check the
meaning of the indicator or message in the following table and take appropriate action.
Toner cartridge replacement
required indicator
Maintenance indicator
Paper required indicator
Indication
Maintenance
indicator
Developer
replacement
required indicator
Toner cartridge
replacement
required indicator
Paper required
indicator
Misfeed indicator
ORIGINAL SIZE indicator
PAPER SIZE indicator
[CH] appears in display
Letters and numbers appear
in the display
When "Use close paper size" is disabled
46
Developer replacement required indicator
Misfeed indicator
Steadily Service by an authorized TOSHIBA service technician is
lit required.
Steadily Developer is required. Contact your authorized service
lit representative.
Steadily Replacement of toner cartridge will be needed soon.
lit Prepare a new cartridge.
Toner cartridge must be replaced. Replace it with a new
Blinking
one.
The tray is out of paper. Load paper. It is also possible that
Steadily
the tray is not inserted completely into the machine. Make
lit
sure it is inserted correctly.
Steadily A paper misfeed has occurred. Remove the misfeed as
lit explained in "MISFEED REMOVAL".
The original is not placed in the correct orientation. Rotate
Blinking the original so that it is in the same orientation as the
blinking ORIGINAL SIZE indicator.
A paper feed location is blinking.
→ A blinking paper feed location means that the size of paper
loaded in the tray is different from the paper size setting for the
tray. Change the paper size setting.
Blinking
To clear the display, do one of the following:
• Use the [TRAY SELECT] key (
selection.
• Open and close the tray.
• Press the [CLEAR] key (
Steadily The front cover or the side cover is open. Close the front
lit cover or the side cover.
The toner cartridge is not installed correctly. Reinstall the
toner cartridge. If [CH] still blinks in the display after
Blinking
reinstalling the toner cartridge, contact your authorized
service representative.
Turn off the power switch, wait about 10 seconds, and then
turn on the switch again. If this does not clear the message,
write down the code that appears and then unplug the
power cord and contact your authorized. Tell service
representative what code appeared and the circumstances
under which it appeared.
The PAPER SIZE indicator on the operation panel will blink.
You can press the [TRAY SELECT] key (
tray manually, or load paper in the bypass tray and press
the [ON LINE] key (
Display
Cause and solution
) to change the tray
) or the [RESET] key (
) to begin printing.
Page
–
–
–
54
14
47
18,19
16
).
–
54
–
) to select a Online
manual