Paper Width; Loading The Bypass Tray - Toshiba e-STUDIO161 Operator's Manual

Loading the bypass tray

1
Unfold the bypass tray.
2 Set the paper guides to the copy

paper width.

Important points when inserting paper in the bypass tray
Up to 100 sheets of standard copy paper can be set in the bypass tray.
•
Be sure to place A6, A5 or ST size paper or envelopes horizontally as shown in the following diagram (
•
When loading envelopes, make sure that they are straight and flat and do not have loosely glued construction
•
flaps (not the closure flap).
Special papers except TOSHIBA recommended transparency film, labels, and envelopes must be fed one sheet at
•
a time through the bypass tray.
When adding paper, first remove any paper remaining in the tray, combine it with the paper to be added and then
•
reload as a single stack. The paper to be added must be the same size and type as the paper already in the tray.
Do not use paper that is smaller than the original. This may cause smudges or unclean images.
•
Do not use paper that has already been printed on by a laser printer or plain paper fax machine. This may cause
•
smudges or unclean images.
When feeding large
paper such as B4 and A3
(LG and LD), pull out the
bypass tray extension.
BEFORE USING THE MACHINE
3
Insert the paper (print face down) all
the way into the bypass tray.
If you loaded paper in the bypass tray, press
Note
the [TRAY SELECT] key (
the bypass tray. The bypass tray will not be
selected automatically.
Available Not available
To prevent a misfeed,
verify once more that the
paper guides are
adjusted to the width of
the paper.
) to select
).
15
1