Epson FX Series Product Support page 125

GENERAL
6.3.2 FX-80/80-i-/FX-100/100-f DIP Switches.
In order to obtain access to the DIP Switches, follow the steps below;
1. Unplug power cord.
2. Remove the screws on SW Access Cover with a Phillips type
screwdriver.
3. Pull the cover in the direction of the arrow with both hands as
shown below.
Fig. 6-1. Removal of SW Access Cover
There are two DIP switches inside the printer. The switches set to the upper
position are ON, to the lower position OFF. Use a small pocket screwdriver to
set switches to the On or OFF position (fig, 6-2).
CAUTION
Do Not use a pencil to change switch positions. Lead from the pencil can
short the switch internally
6-4
o
EPSON PRINTERS
1 J 3 4?
i j 3 4 & 6 ; 6
BBBBeBBBs
SW2 SWl
Fig. 6-2. Location and Setting of DIP Switches