Table of Contents
Advertisement
ICC
5)
Configure the MSG instruction.
a)
Set the "Read/Write" field to "Read", "Target Device" field to "PLC5",
"Local/Remote" field to "Local", and "Control Block" to "N20:0".
b)
Upon hitting the <ENTER> key while in the "Control Block" entry box,
the MSG Properties dialog box should appear (or it can be opened by
clicking on the "Setup Screen" button at the bottom of the MSG
instruction). Refer to Figure 92.
Figure 92: MSG Configuration, "General" Tab
Figure 91: XIO Instruction Selection
89
Advertisement
Table of Contents
