Table of Contents
Advertisement
ICC
11.3 Using FTP with a Windows Command Prompt
To use FTP with a Windows command (DOS) prompt, first open a command
prompt by either selecting Start...All Programs...Accessories...Command
Prompt, or by selecting Start...Run and typing "cmd" in the "Run" dialog.
Once the command prompt opens, type "ftp" and the IP address of the target
interface card. The FTP client will connect to the unit and then prompt for the
username and case-sensitive password (defaults are "root" and "icc",
respectively). Upon successful entry of the authentication information, you will
be presented with an "ftp>" prompt. Refer to Figure 57.
Figure 57: FTP Initiation and Authentication
At this point, you can use standard Unix-style file and directory manipulation
commands to perform such actions as listing files (Figure 58), copying files to
your computer (Figure 59), and copying files to the unit (Figure 60).
Figure 58: Listing Files with "ls" Command
56
Advertisement
Table of Contents
