Blaupunkt FREIBURG RCR 127 Operating Instructions Manual page 6

7 FMT (Freiburg RCR 127,
Colorado RCR 127)
BND (Montreux RCR 127)
For selection of the FM memory banks
I, II and T (Travelstore).
To switch over:
Press button repeatedly.
The selected memory bank will appear
in the display.
Travelstore
To store and recall the six most power-
ful stations with Travelstore.
To store: Press button for approxi-
mately 1 sec. until you hear a beep
and "T-STORE" appears in the display.
To recall: Select the memory bank "T"
and press the corresponding preset
button (1-6) briefly.
Montreux RCR 127:
Additional selection of medium- and
long-wave stations, provided that "AM
ON" has been adjusted in the DSC
menu.
26
8 AF
Alternative frequency during RDS op-
eration:
When "AF" lights up in the display, the
system will automatically seek a fre-
quency offering better reception of the
same RDS programme.
AF on/off: Press AF briefly.
Regional function on/off:
Press the AF button for approximately
1 sec. until you hear a beep. "REG-
ON" or "REG-OFF" will appear in the
display (see chapter REG - regional
programme).
9 TA (priority for traffic announcements)
When "TA" lights up in the display, the
system will play traffic stations only.
Priority on/off: Press TA.
: 1, 2, 3, 4, 5, 6 - preset buttons
You can store six stations for each of
the memory banks I, II and T.
To store a station: Press a preset
button during radio operation and hold
down until the set resumes play after
the muting and you hear a beep.
To recall a station: Select the desired
memory bank and press the relevant
preset button briefly.
Extra function of preset buttons
To store and recall a PTY programme
type.
When PTY is active ("PTY" lights up in
the display), you can store and recall
one programme type on/from each
preset button on FM.
; SRC (Source)
You can switch between the radio and
tape audio sources (if a tape is insert-
ed).
< lo
To switch the seek tuning sensitivity
level:
Press button briefly.
If "lo" is displayed, the radio will only
pick up strong, local stations (normal
sensitivity).
If "lo" does not light up, the radio will
also pick up weaker, distant stations
(high sensitivity).
Extra function of lo button:
To switch between mono and stereo
reception:
Press button for approximately 1 sec.
(beep).
The selected condition will be briefly
displayed.