Table of Contents
Advertisement
If you leave the service area of the regional
programme tuned into, or if you would like
to take advantage of the full RDS service,
switch to "REG OFF".
•
Press the AF button for approximately
1 sec. until "REG OFF" appears.
If the REG function is active, "REG ON" will
be briefly displayed each time the radio is
switched on.
Selecting a waveband
(only Montreux RCR 127)
You can select between the following wave-
bands:
FM 87.5 - 108 MHz
MW 531 - 1602 kHz
LW 153 - 279 kHz
•
Press the BND button until the desired
waveband shows on the display panel.
Note:
In the DSC menu you can deactivate the
station selection on either MW or LW or for
both wavebands at the same time.
This has the advantage that only the re-
quired bands will allow to be activated, so
that you must press the BND button less
often. For more information, please refer to
chapter "DSC programming - AM ON/OFF".
32
Station tuning
Automatic tuning
/
•
Press
/ ; the car radio will automati-
cally search for the next station.
When keeping the upper or lower part
of the rocker switch depressed, seek tuning
will speed up in upwards or downwards di-
rection.
Seek tuning
Up
Down
<< / >> Up/Down in short intervals
(FM only, "AF" must be switched off)
Manual tuning with << >>
You can also tune in a station manually.
Condition:
AF and PTY must be switched off (i.e. the
symbols do not light up in the display).
If necessary, deactivate these functions:
•
Press AF or PTY briefly.
Manual tuning:
•
Press << >>; the frequency will change
in short intervals in downwards or up-
wards direction.
When holding the right or left part of the rock-
/
er switch depressed, the frequency scan is
speeded up.
Scrolling through the broadcast-
ing networks
(FM only)
You can use the << >> buttons to tune in
stations of your reception area.
If several programmes of the broadcasting
networks can be received, you can scroll
through them in forwards direction pressing
>>, or backwards using the << button, e.g.
NDR 1, 2, 3, 4, N-JOY, FFN, ANTENNE ...
For this it is necessary that the stations have
been tuned in at least once and that "AF" is
active (lights up in the display).
For this purpose, start automatic tuning, e.g.
using Travelstore:
•
Press FMT or BND for 1 sec.; the
system starts to run through the fre-
quency band. The display shows
"T-STORE".
If "AF" does not light up,
•
press AF.
This fulfils the requirements for selecting
stations with << >>.
Hide quick links:
Advertisement
Table of Contents
