Blaupunkt ALICANTE Alicante CD31 Operating Instructions Manual

Blaupunkt radio/cd operating instructions
Hide thumbs Also See for ALICANTE Alicante CD31:

Advertisement

Radio / CD
Operating instructions

Advertisement

Table of Contents
loading

Summary of Contents for Blaupunkt ALICANTE Alicante CD31

  • Page 1 Radio / CD Operating instructions...
  • Page 3 button to release the control panel. FMT button (Essen CD31) to se- lect the FM memory levels, to switch to radio mode, to start the Travelstore function. BAND button (Alicante CD31 and Lausanne CD31), to select the FM memory levels and MW / LW frequency range, to switch to radio mode, TS, to start the Travelstore func-...
  • Page 4: Table Of Contents

    Notes and accessories ... 27 Road safety ... 27 Installation ... 27 Accessories ... 27 Removable control panel ... 28 Switching on/off ... 29 Adjusting the volume ... 30 Setting the power-on volume ... 30 Instantaneous volume reduction (mute) ... 30 Mute during telephone operation ...
  • Page 5: Road Safety

    CD changers: CDC A 06, CDC A 08, CDC A 072 and IDC A 09. You can also connect the CDC A 05 and CDC A 071 CD changers by using an adapter cable (Blaupunkt no. 7 607 889 093).
  • Page 6: Removable Control Panel

    As a way of protecting your car radio against theft, the unit is equipped with a removable control panel (release pan- el). Without this control panel, the car radio is worthless to a thief. Protect you car radio against theft by taking the control panel with you every time you leave your vehicle.
  • Page 7 There are various ways of switching the unit on/off: If the unit is correctly connected to the vehicle’s ignition and it was not switched off using button >, it will switch on/off simultaneously with the ignition. You can also switch the unit on even if the ignition is off: To do so, press button >.
  • Page 8 The system volume can be adjusted in steps from 0 (off) to 66 (maximum). To increase the system volume, button =. press the To decrease the system volume, button =. press the You can set the default volume at which the unit switches on.
  • Page 9: Confirmation Beep

    For some functions you will hear a con- firmation beep if you keep a button pressed for longer than two seconds. For instance, after storing a radio sta- tion to a station button you will hear a confirmation beep. The beep can be switched on/off.
  • Page 10 This unit is equipped with an RDS radio receiver. Many of the receivable FM sta- tions transmit a signal that not only car- ries the programme but also additional information such as the station name and programme type (PTY). The station name appears in the dis- play as soon as it is received.
  • Page 11 This unit can receive programmes broadcast over the FM, MW and LW fre- quency ranges. Note: The MW and LW frequency ranges are not available on the Essen CD31. There are three preset memory levels for the FM range and one for each of the MW and LW ranges.
  • Page 12 Note: If you want to use this feature, the RDS function must be activated. button 9 to Press the switch to the next station on the broadcasting network. When using this feature, you will only be able to switch to stations that you have received once already.
  • Page 13 Press the MENU button :. Keep pressing the 9 until “SCANTIME” appears in the display. Set the required scantime using buttons 9. When you have finished making your changes, press the MENU button : twice. Note: The set scantime also applies to scanning in CD and CD changer mode.
  • Page 14 The selected programme type is dis- played briefly. button 9 to start Press the seek tuning. The next station corresponding to your selected programme type will then be tuned into. Select a programme type using the button 9. Press and hold the required button 1 - 5 ;...
  • Page 15 Press the TRAF button <. Traffic announcement priority is active when a traffic jam symbol lights up in the display. Note: You will hear a warning sound if you leave the reception area of a traffic information station that you are currently listening to.
  • Page 16: Keep Pressing The Cd•C Button 7

    You can use this unit to play standard CDs with a diameter of 12 cm. Risk of damage to the CD drive! CD singles with a diameter of 8 cm and contoured CDs (shape CDs) are not suitable for playback in this unit. We accept no liability for any dam- age to the CD drive that may occur as a result of the use of unsuitable...
  • Page 17 To stop scanning, press the SCAN button 4 again. The current track will then continue to be played. If you want to repeat a track, press button 3 (RPT) ;. RPT appears in the display. The track is repeated until you deactivate RPT. If you want to cancel the repeat func- tion, press button 3 (RPT) ;...
  • Page 18 Note: Information on handling CDs, in- serting CDs and operating the CD changer can be found in the oper- ating instructions supplied with your CD changer. Keep pressing the CD•C button 7 until “CHANGER” appears in the display. Playback begins with the first CD that the CD changer detects.
  • Page 19 To stop the current track or current CD from being repeated, keep pressing button 3 (RPT) ; until “RPT OFF” appears in the dis- play and RPT disappears. To play the tracks on the current CD in random order, briefly press button 4 (MIX) ;. “MIX CD”...
  • Page 20: Keep The Menu ( ) Button

    To display the time, Keep the MENU ( ) button : pressed until the time appears in the display. Press the MENU button :. Keep pressing the 9 until “CLOCKSET” appears in the display. button 9. Press the The time appears in the display. The minutes flash on and off and can be adjusted.
  • Page 21: Keep Pressing The Or Button

    To adjust the BASS, press the AUDIO button 8. “BASS” appears in the display. button 9 to ad- Press the just the bass. When you have finished making your changes, press the AUDIO button 8. To adjust the TREBLE, press the AUDIO button 8. “BASS”...
  • Page 22: Press The Or Button

    CD player, MiniDisc player or MP3 player. If you want to connect an external au- dio source you will need a Blaupunkt adapter cable (Blaupunkt no.: 7 607 897 093). The AUX input must be activated in the but- menu.
  • Page 23: Guarantee

    If you wish to enforce a claim under the manufacturer’s guarantee that is provid- ed by Blaupunkt, please send the faulty unit together with the purchase receipt to the Blaupunkt customer service cen- tre in your country. You can find out...

This manual is also suitable for:

Essen cd31Lausanne cd31

Table of Contents