Table of Contents
Advertisement
When installing Wireless LAN cards, the channel configuration is
managed as follows:
For wireless clients that operate in a Wireless LAN Infrastructure, the
Wireless LAN card will automatically start operation at the channel
identified by the Wireless LAN Access Point. When roaming between
different access points the station can dynamically switch to another
channel if required.
For Wireless LAN cards installed in wireless clients operating in a
peer-to-peer mode, the card will use the default channel 10.
In a Wireless LAN Access Point, the Wireless LAN card will use the
factoryset default channel (printed in bold), unless the LAN
Administrator selected a different channel when configuring the
Wireless LAN Access Point device.
Wireless IEEE 802.11 Channels Sets (Revision A)
Frequency Range Channel ID
* Available Area: US (USA, CANADA) only
A peer-to-peer mode is available under the following condition:
A Wireless LAN card receives a "US county/region code" beacon of the
standard IEEE 802.11 (Revision D) from a Wireless LAN Access Point.
Wireless Channels Sets (Turbo Mode)
Frequency Range Channel ID
* Available Area: US (USA, CANADA) only
TOSHIBA TE2300
36
40
44
48
52
56
60
64
149
153
157
161
42
50
58
152
160
5150-5850 MHz
5180
5200
5220
5240
5260
5280
5300
5320
5745
5765
5785
5805
5150-5850 MHz
5210
5250
5290
5760
5800
Wireless LAN
Note
US only *
US only *
US only *
US only *
Note
US only *
US only *
US only *
US only *
US only *
I-3
Advertisement
Table of Contents
