Table of Contents
Advertisement
2. Enter the currently registered password. The character string you
enter is displayed as a string of asterisks.
If you click the OK button before entering the password, Registered
will appear on the display.
3. Click the OK button. If the character string you enter matches the
registered password, the password option is reset and the display
changes to:
If they do not match, the following message appears. You must
repeat step 1.
If you enter the password incorrectly three times in a row, the computer
needs to shut down.
You will not be able to access the password option in HW Setup. In this
case you must turn the power off and back on to retry the procedure.
4. Follow the same procedures described earlier in this section to set a
new user password.
Device Config
Device Configuration
This option lets you set the device configuration.
All Devices
Setup by OS
Parallel/Printer
This tab lets you set the Printer Port Type. Use the Windows Device
Manager to make settings for the Parallel port.
Parallel Port Mode
The options in this tab are ECP and Standard Bi-directional.
ECP
Standard
Bi-directional
TOSHIBA TE2300
Enter Password: ****
Not registered
Incorrect Password!!!
BIOS sets all devices.
Operating system sets devices that it can
control.
Sets the port type to Extended Capabilities Port
(ECP). For most printers, the port should be set
to ECP. (Default)
This setting should be used with some other
parallel devices.
HW Setup and Passwords
7-3
Advertisement
Table of Contents
