Closing The Access Point Hinged Cover - Cisco 1552S Installation Manual

Chapter 3 Installing the 1552 Series Access Points in Hazardous Locations
To open the access point hinged cover, follow these steps:
Use 0.5-in (13-mm) box-end wrench or socket set to unscrew and remove the four bolts on the front cover
Step 1
of the unit. Only unscrew the hinge bolts about 2 turns until they are easily turned by hand, do not remove
the bolts on the hinge
The cover is hinged on the bottom. Carefully open the cover and remove the cover.
Step 2
Note
Figure 3-10
1

Closing the Access Point Hinged Cover

To close the access point cover, follow these steps:
When closing the access point cover, be careful not to pinch internal wires.
Step 1
Carefully position the cover flush with all sides of the access point, then slowly hand-tighten each bolt.
Step 2
When all bolts are hand-tightened, use a 13-mm closed-end wrench or socket to partially tighten the bolts
Step 3
in the tightening sequence shown in
Repeat
Step 4
(0.68 to 0.79 Nm).
(Figure 3-10).
If the cover does not open easily, carefully loosen the hinge bolts again.
Access Point Front View of Hinged Cover
1
M8 x32 bolts
Step 3 using the same tightening sequence to fully tighten each bolt to 6 to 7 ft lbs
1 1
2 2
2 Cover hinge M8 x32 bolts
Figure 3-11. Tighten each bolt to 3 to 4 ft lbs (0.34 to 0.45 Nm).
Cisco Aironet 1552 Series for Hazardous Locations Installation Guide
Working with the Access Point Hinged Cover
1
3-59