Cisco 1552S Installation Manual page 70

Mounting on a Wall or a Pole
Install four M8 x16 bolts (with flat and lock washers) into the bolt holes.
Step 8
Figure 3-7
1
Pole clamp bracket assembly
2 Access point support bolt
(M8 flange nut not shown)
Hand-tighten the bolts and the nut (do not overtighten).
Step 9
Adjust the top edge of the mounting bracket until it is horizontal and tighten the bolts and the flange nut
Step 10
(see Figure
Note
Screw a M8 x16 bolt (without a flat or lock washer) in the top support bolt hole on each side the access
Step 11
point (see
(0.635 cm).
Cisco Aironet 1552 Series for Hazardous Locations Installation Guide
3-56
Screw Hole Locations on the Mounting Bracket and Pole Clamp Bracket Assembly
3-7) to 13 to 15 ft lbs (17.6 to 20.3 Nm).
The mounting bracket can be adjusted up to 45
poles.
Figure 3-8). Do not screw the bolt all the way in. Leave a gap of approximately 0.25 inch
Chapter 3 Installing the 1552 Series Access Points in Hazardous Locations
1
2
4
3
3
3
Bolt holes
4 Mounting bracket
o
to compensate for tilted horizontal streetlight
3