Cisco 1552S Installation Manual page 71

Chapter 3 Installing the 1552 Series Access Points in Hazardous Locations
Figure 3-8
1 Ground lug screw holes location. M4x.7
2 M8 x16 bolt hole (bolts are supplied with pole
mount kit; install without flat or lock washers)
Position the two bolts on the access point into the access point quick-mount notch on the mounting
Step 12
bracket (see
Note
Location of Access Point Top Support Bolt Holes
Figure 3-9).
The access point should be positioned with the LEDs on the bottom to allow viewing from the
ground and with the hinged cover facing out.
3 Second M8 x16 bolt hole location
Cisco Aironet 1552 Series for Hazardous Locations Installation Guide
Mounting on a Wall or a Pole
1
2
3
3-57