C Leaning And Maintaining The Xs Wireless Systems; If A Problem Occurs - Sennheiser XS Wireless Series Instruction Manual

C leaning and maintaining the XS WIRELESS systems

C leaning and maint aining t he XS WIRELESS syst ems
C AUTION
Liquids can damage t he elect ronics of t he products!
Liquids entering the housing of the products can cause a short-circuit and damage the
electronics.
Keep all liquids away from t he products.
E
Do not use any solvent s or cleansing agents.
E
Before cleaning, disconnect the receiver from the mains.
E
Only use a soft, slightly damp clot h to clean the products.
E

If a problem occurs ...

Problem C ause
No operation Bat teries are flat
indication
No mains connection (receiver) C heck the connections of the
No RF signal Transmitter and receiver are not
on the same channel
Transmission range is exceeded Reduce t he distance between
RF signal avail- Receiver's squelch t hreshold is
able, no audio adjusted too high
signal
Audio signal Transmitt er sensitivity is
has a high level adjust ed too low or too high
of background
Receiver's audio output level is
noise or is
adjust ed too low or too high
distorted
Interference of Distance bet ween transmitting
the RF signal and receiving antennas is too
small
Several transmitters/ radio
microphones are used simulta-
neously and the distance
between t wo t ransmitters is
too small
12 | XS WIRELESS
Solut ion
Replace the batteries.
mains unit .
Set transmitter and receiver to
t he same channel.
t ransmitter and receiver.
Reduce the squelch threshold.
Adjust the sensitivity on the
t ransmitter.
Use the volume control 7 to
adjust the audio level.
Distance > 5 m
Distance > 20 cm
Page
8
7
10
–
11
10
7
–
–