JRC JSS-2150 Instruction Manual page 175

■
Replacing the ink ribbon
1 1 . .
1 .
Turn off the printer and following the same
procedure as that in the previous section,
open the printer cover, lift up the ink ribbon
cartridge by holding the projection on the
cartridge, and lift up the cartridge to
remove it.
2 2 . .
2 .
Using the knob on the new cartridge make
the ribbon taut. Then manually move the
print head to the left edge, and attach the
ribbon with such a pen so that it is between
the ribbon mask and print head.
After attaching the ink ribbon cartridge,
Note
check if turning the knob moves the ink
ribbon normally.
3 3 . .
3 .
Close the printer cover.
■
Options Operation
Ink ribbon
cartridge
Projection
Print head
Knob
10-13