Tape Duplication (For Vr788/55) - Philips VR888/55 User Manual

Tape Duplication (For VR788/55 only)
Connection
Diagram
Playback VCR
OUT
AV1. IN / OUT
To AV1 IN/OUT terminal
IN
Dubbing from any VHS VCR (or video
camera) to another is simple.
Explanations on this page uses this
VCR as the recording VCR.
Refer also to the manual supplied with
the other VCR (for playback).
You can also use the AUDIO/VIDEO
input jacks on the front panel to
connect another VCR or video camera
using the audio/video cable (RCA pin-
type).
To audio
output
To video
output
POWER
STILL/PAUSE
VIDEO L AUDIO R COLOUR
MODE
VR788/888-55 NEW
1 Connect the recording VCR (this VCR) and the playing
VCR.
2 Connect the recording VCR (this VCR) to the TV.
Recording VCR (this VCR)
ANT. IN
RF OUT
SCART cable
Make sure....
• Use the appropriate SCART cable
depending on the other VCR's AV
terminal.
1
At VCRs
Insert a source tape in the playing VCR
and a blank tape in the recording VCR.
• If a tape without the record tab is inserted
in the playing VCR, playback automati-
cally starts. In this case, press the STOP
button.
2
At TV
Turn the channel on the TV to your
video channel.
3
Select Line Input
Press CH 5 or ∞, pointing the remote
control at this VCR, to select the
external line input.
• For rear jacks,
Select "L-1" on the display panel.
• For front jacks,
Select "L-F" on the display panel.
— 23 —
23
OUT
ANT. IN
AV1. IN / OUT
To RF OUT
RF OUT
To AV1 IN/OUT terminal
4
Select Tape Speed
Press SPEED, pointing the remote
control at this VCR, until the desired
tape speed (SP, LP, or SLP) appears on
the display.
SP, LP : For PAL signal
SP, SLP : For NTSC signal
5
Play Back Tape
Press the PLAY button on the playback
VCR.
6
Record (Copy) Tape
Press REC/OTR (¶), pointing the
remote control at this VCR.
Remember: press the buttons in steps 5
and 6 simultaneously to avoid missing
any of the recording.
6/3/99, 11:52 PM
TV