Tape Duplication (For Vr888/55) - Philips VR888/55 User Manual

A
DVANCED
Tape Duplication (For VR888/55 only)
Connection
Diagram
Playing VCR
IN OUT
R
AUDIO
(MONO)
L
VIDEO
From Audio output to AUDIO IN
From Video output to VIDEO IN
Dubbing from any VHS VCR (or video
camera) to another is simple.
Explanations on this page uses this
VCR as the recording VCR.
Refer also to the manual supplied with
the other VCR (for playback).
• You can also use the AUDIO/VIDEO
input jacks on the front panel to
connect another VCR or video
camera.
• The remote control operation mode
is set correctly for operating your
target component.
– Press VCR to operate the VCR.
– Press TV to operate the TV.
VR788/888-55 NEW
O
PERATIONS
1 Connect the recording VCR (this VCR) and the playing
VCR.
2 Connect the recording VCR (this VCR) to the TV.
Recording VCR (this VCR)
ANT. IN
RF OUT
1
At VCRs
Insert a source tape in the playing VCR
and a blank tape in the recording VCR.
• If a tape without the record tab is inserted
in the playing VCR, playback automati-
cally starts. In this case, press the STOP
button.
2
At TV
Turn the channel on the TV to your
video channel.
3
Select Line Input
Press CH 5 or ∞, pointing the remote
control at this VCR, to select the
external line input.
• For rear jacks,
Select "L-1" on the display panel.
• For front jacks,
Select "L-F" on the display panel.
— 22 —
22
(C
ONTINUED
IN OUT
ANT. IN
R
To RF OUT
AUDIO
(MONO)
L
RF OUT
VIDEO
4
Select Tape Speed
Press SPEED, pointing the remote
control at this VCR, until the desired
tape speed (SP, LP, or SLP) appears on
the display.
SP, LP : For PAL signal
SP, SLP : For NTSC signal
5
Play Back Tape
Press the PLAY button on the playing
VCR.
6
Record (Copy) Tape
Press REC/OTR, pointing the remote
control at this VCR.
Remember: press the buttons in steps 5
and 6 simultaneously to avoid missing
any of the recording.
6/3/99, 11:52 PM
)
TV