Testing ISDN BRI functions
Testing an ISDN BRI trunk
Perform procedure to test an ISDN BRI trunk DSL
1. Set up the ISDN trunk test configuration to be used, as described previously in the
2. Place a call across the ISDN BRI trunk.
3. Complete the call and hang up.
Removing the test setup
After acceptance testing is completed and the results show the system is operating correctly,
remove the ISDN BRI terminal setup and configure ISDN BRI equipment according to the
customer configuration. If the actual customer configuration was used to perform these tests,
no changes are needed.
94
ISDN Basic Rate Interface Installation and Commissioning
chapter "Set up ISDN BRI test terminals and trunks".
March 2011