Juniper MX10016 Quick Start Manual page 31

WARNING:
Permit only trained and qualified personnel to install or replace router components.
Perform only the procedures described in this quick start guide and the MX10016 router documentation. Other services
must be performed only by authorized service personnel.
Before installing the router, read the planning instructions in the MX10016 router documentation to make sure that
the site meets power, environmental, and clearance requirements for the router.
Before connecting the router to a power source, read the installation instructions in the MX10016 router documentation.
A base configuration is about 533 lb (241.77 kg) and redundant configurations can weigh 596 lb (270.34 kg). Installing
the MX10016 router in a rack or cabinet requires either a mechanical lift or three people to lift the router and another
person to secure it to the rack. To prevent injury, keep your back straight and lift with your legs, not your back.
If the rack or cabinet has stabilizing devices, install them in the rack before mounting or servicing the router in the rack
or cabinet.
Before installing or after removing an electrical component, always place it component-side up on a flat antistatic mat
or in an electrostatic bag.
Do not work on the router or connect or disconnect cables during electrical storms.
Before working on equipment that is connected to power lines, remove jewelry, including rings, necklaces, and watches.
Metal objects heat up when connected to power and ground and can cause serious burns or become welded to the
terminals.
CAUTION:
transceiver. Damage to the access ports will occur.
Power Cable Warning (Japanese)
The attached power cable is only for this product. Do not use this cable for any other product. For technical support, see
https://www.juniper.net/support/requesting-support.html.
Failure to observe these safety warnings can result in personal injury or death.
Do not place a copper transceiver in an access port directly above or below another copper
31