Table of Contents
Advertisement
Figure 21: Removing the PSU Cover Panel
12. Unscrew the captive screw in the counterclockwise direction by using the Phillips (+) screwdriver, number 1.
13. Pull the captive screw away from the faceplate of the power supply to release the latch.
NOTE:
You can install the power supplies in any slot labeled PSU 0 through PSU 9 (top to bottom).
14. Using both hands, place the power supply in the power supply slot on the rear of the router. Slide the power supply
straight into the chassis until the power supply is fully seated in the slot. Ensure that the power supply faceplate is
flush with any adjacent power supply faceplates or power supply cover panels (see
15. Push the captive screw into the power supply faceplate. Ensure that the screw is seated inside the corresponding hole
on the faceplate.
16. Tighten the captive screw by turning it clockwise by using the Phillips (+) screwdriver, number 1. When the screw is
completely tight, the latch locks into the router chassis.
Figure
22).
26
Advertisement
Table of Contents
