Table of Contents
Advertisement
7. Tighten the two 10-32 screws using a Phillips screwdriver and apply torque between of 30.1 in.-lb (3.4 N-m) and 42.04
in.-lb (4.75 N-m).
8. Dress the grounding cable and ensure that it does not touch or block access to other device components and that it
does not drape where people can trip over it.
Install AC Power Supplies
MX10016 power supplies are hot-insertable and are field-replaceable units (FRUs). You can install up to 10 power supplies
in an MX10016. The power supplies install in the rear of the chassis in the slots provided along the left side.
CAUTION:
Before you install an AC power supply in the router, ensure that you have the following parts and tools available to install
an AC power supply in an MX10016:
Electrostatic discharge (ESD) grounding strap
Phillips (+) screwdriver, number 1
Power cords appropriate for your geographical location
Power cord retainer clips
To install an AC power supply in an MX10016 :
1. Attach the electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to the ESD point
on the chassis. There is an ESD point located next to the protective earthing terminal and below PSU 9 on the rear
panel.
2. If the power supply slot has a cover panel on it, insert your thumb and forefinger into the finger holes, squeeze and
pull the cover out of the slot. Save the cover panel for later use. See
Do not mix AC and DC power supplies in the same chassis.
Figure
17.
19
Advertisement
Table of Contents
