Safety Information - Sony Bravia FW-85BZ35F Reference Manual

To reset the TV to ENERGY RATING qualified settings, complete
the initial set-up procedure in [Settings] t [Storage & reset] t
[Factory data reset].
After factory data reset, downloaded application data will be
deleted. Please download them again.

Safety Information

WARNING
Caution
Risk of explosion if the battery is replaced by an incorrect type.
Batteries must not be exposed to excessive heat such as
sunshine, fire or the like or extremely low air pressure that can
result in an explosion or leakage of flammable liquid or gas.
Stability Hazard
The LCD Monitor may fall, causing serious personal injury or
death.
Never place a LCD Monitor in an unstable location. A LCD Monitor
may fall, causing serious personal injury or death. Many injuries,
particularly to children, can be avoided by taking simple
precautions such as:
• Using cabinets or stands recommended by the manufacturer of
the LCD Monitor.
• Only using furniture that can safely support the LCD Monitor.
• Ensuring the LCD Monitor is not overhanging the edge of the
supporting furniture.
• Not placing the LCD Monitor on tall furniture (for example,
cupboards or bookcases) without anchoring both the furniture
and the LCD Monitor to a suitable support.
• Not placing the LCD Monitor on cloth or other materials that
may be located between the LCD Monitor and supporting
furniture.
• Educating children about the dangers of climbing on furniture
to reach the LCD Monitor or its controls.
If your existing LCD Monitor is being retained and relocated, the
same considerations as above should be applied.
Installation/Set-up
Install and use the LCD Monitor in accordance with the
instructions below in order to avoid any risk of fire, electric shock
or damage and/or injuries.
Installation
• The LCD Monitor should be installed near an easily accessible AC
power outlet (mains socket).
• Place the LCD Monitor on a stable, level surface to prevent it
from falling over and causing personal injury or property
damage.
• Install the LCD Monitor where it cannot be pulled, pushed, or
knocked over.
• Install the LCD Monitor so that the LCD Monitor's Table-Top
Stand does not protrude out from the LCD Monitor stand (not
supplied). If the Table-Top Stand protrudes out from the LCD
Monitor stand, it may cause LCD Monitor to topple over, fall
down, and cause personal injury or damage to the LCD Monitor.
• Only qualified service personnel should carry out wall-mount
installations.
• For safety reasons, it is strongly recommended that you use
Sony accessories, including:
 Wall-Mount Bracket SU-WL500 (FW-85/75BZ35F only)
 Wall-Mount Bracket SU-WL450 (Except FW-85/75BZ35F)
• Be sure to use the screws supplied with the Wall-Mount Bracket
when attaching the Wall-Mount Bracket to the LCD Monitor. The
supplied screws are designed as indicated by illustration when
measured from the attaching surface of the Wall-Mount Bracket.
The diameter and length of the screws differ depending on the
Wall-Mount Bracket model.
Use of screws other than those supplied may result in internal
damage to the LCD Monitor or cause it to fall, etc.
FW-85/49/43BZ35F
8 mm – 12 mm
FW-75/65/55BZ35F
10 mm - 13 mm
Transporting
• Before transporting the LCD Monitor, disconnect all cables.
• Two or more people (three or more people for FW-85BZ35F) are
needed to transport a large LCD Monitor.
• When transporting the LCD Monitor by hand, hold it as shown
below. Do not put stress on the LCD panel and the frame around
the screen.
Screw (M6)
Wall-Mount Bracket
LCD Monitor's rear cover
Screw (M6)
Wall-Mount Bracket
LCD Monitor's rear cover
3
GB
GB