Step 4: Replacing The Wiper And Felt Wiper - Roland SOLJET PRO4 XR-640 Manual


Press .


STEP 4: Replacing the Wiper and Felt Wiper

If a warning beep sounds during operation
Attach the left and right covers, close the front cover, and then press
the operations with the procedures in this manual.
and perform the operations according to the details listed under
CAUTION
Be sure to perform operations as specified by the instructions, and never touch any
area not specified in the instructions.
Failure to observe these instructions may cause the machine to move suddenly, resulting
in injury.
1.
Replace the wiper.



Detach the old wiper.
Disconnect the hooks.
Using the tweezers to press on the
hook in the hole on the wiper makes
it easier to remove the wiper.
Attach the right cover.
Lower the cover in the direction indicated by
the cover on the hook, and then lower the cover in the direction
indicated by
You will open the cover again later in the procedure, so there is no
need to fix the cover in place with screws.
When the screen shown in the figure appears, the cleaning of the periphery of the
print heads (manual cleaning) is finished. Proceed to the next procedure.
Refer to the user's manual of the model that you are using

Open the front cover.
Remove the right cover.
Preparations are complete when this screen appears.
Pull up
and out.
Hook
.
. After this, you cannot continue
P. 23 "When Operations Are Interrupted"
ECO-SOL MAX 3 Ink Switching Method
Switching the Ink
in order to catch
.
11