Technical Specifications For Operation In Hazardous Areas - Siemens SIPROCESS GA700 Compact Operating Instructions

Table 10- 41 CALOMAT 7: Climatic conditions
Climatic conditions
Storage and transport
Max. permissible ambient temperature
surrounding the basic device during
operation
Ambient humidity (relative humidity)
during storage, transport or operation
Restriction for installing an ULTRAMAT 7 analyzer module: 5 to 45 °C
1)
Avoid condensation on the installed components!
2)
Table 10- 42 CALOMAT 7: Gas connections
Gas connections
Connection fittings
Table 10- 43 CALOMAT 7: Parts in contact with sample gases
Materials of wetted parts
Gas connection
Clamping rings and union nut (set)
Sample gas pipes
Sensor mounting block
Sensor
Gasket, contained in the sensor
module
10.3

Technical specifications for operation in hazardous areas

The following tables show the data relevant to explosion protection. If the values specified
below deviate from the values of the general technical specifications, the specifications listed
in this section apply.
Compare the specifications in this section with the specifications in the section "General
technical specifications (Page 83)".
Note
Validity of technical specifications
The technical specifications for explosion-proof devices are only valid in combination with the
EC type-examination certificate. The technical specifications listed below are regarded as
general. If these values deviate from those of the EC type-examination certificate, the values
of the EC type-examination certificate apply.
Devices in explosion-proof design
Compact Operating Instructions, 05/2018, A5E35134047-03
10.3 Technical specifications for operation in hazardous areas
1)
-30 to +70 °C
0 to 50 °C
< 90%
2)
Pipe diameter 6 mm (outer diameter)
Stainless steel (Material No. 1.4571)
Stainless steel (Material No. 1.4401)
Stainless steel (Material No. 1.4404)
Stainless steel (Material No. 1.4571)
Si, SiO N , Au, epoxy resin, glass
x y
Perfluorelastomere FFPM
Technical specifications
97