Troubleshooting
Checking Fault Codes
If the diagnostic light indicates that there is a system fault, check the fault codes to determine what is wrong with
the machine; refer to
Diagnostic Light (page
Entering Diagnostic Mode and Checking the Codes
1.
Turn the key to the O
2.
Pull the tethered cap off of the 2 diagnostic, shunt connectors
3.
Connect the diagnostic, shunt connectors together
4.
Turn the key to the R
5.
Count the number of flashes to determine the fault code, then consult the following table:
Note:
If there are multiple faults, both faults will flash, then a long pause, then the flash sequences
will repeat.
12).
position to turn off the power.
FF
position to turn on the power.
UN
(Figure
(Figure
38, B).
Figure 38
31
38, A).
g029822