Table of Contents
Advertisement
2.1 Lift installation
1） Install the lift in your work site. Make sure the environment satisfies the following conditions:
- A flat surface indoor (area where exhaust from the pump does not affect peripheral equipment)
- Enough space for up/down movement of the lift (full height of the lift: 2503mm)
- Enough space to perform maintenance
2） Attach the angles to the lift base with the furnished bolts and washers.
You can use either one of the two mounting positions shown below. Be sure to put one angle in each corner.
(Fig. 3)
3） Secure the angles to the floor using anchor bolts (M12, sold separately).
Right-left position
2.2 Discharge piping
1） Connect a discharge hose to the pump outlet. Make sure the hose satisfies the following requirements:
- Resistant to material being pumped and unaffected by environment
- Satisfying the following normal operation pressure:
- 13×1 ratio pump: 10MPa or more
- 25×1 ratio pump: 18MPa or more
- 38×1 ratio pump: 27MPa or more
- 50×1 ratio pump: 35MPa or more
- Recommended size: 3/4 inch or more
- Hose fitting or joint: <140 Type>Connectable to G3/4(F) material outlet, hose union with a 30 degree male seat
- Flexible hose, comfortable length for up/down movement of the lift
2） Connect the other end of the hose to a delivery pipeline. Attach a valve at the connection between the hose and
the piping for maintenance and keep it closed until unit installation is completed.
2.3 Air piping
1） Attach an emergency stop valve to the air pipe (somewhere accessible between the air source and unit).
2） Select an air supply hose, fitting, and air equipment that satisfy the following requirements. With these devices,
connect an air piping and the air inlet of the lift. Be careful not to let the hose get caught on peripheral
equipment.
- Designed for use with air and unaffected by environment
- Normal operation pressure: 0.7MPa or more
- Recommended size: 3/8 inch or more
- Hose fitting or joint: Connectable to Rc1/2 air inlet
- Comfortable hose length for up/down movement of the lift
- Flow rate: 1300L/min (ANR) or more
Mounting positions
of angles
Fig. 3 Mounting positions of angles
<125 Type>Connectable to Rc3/4 material outlet
Front-back position
3
Advertisement
Table of Contents
