Consumables; Design Standard Use Period - YAMADA 140 Series Instruction Manual

4.3 Consumables

1） Pump
Refer to "Instruction Manual for APP067U" for replacement time for consumables used in the pump. The
replacement time should be used only as a guide. Consumption varies depending on use conditions. Also, be
sure to replace a part when you find any defect like a leak during operation.
2） Lift
- The plastic tubes will be degraded naturally. Replace them all every six years.
- The switches and regulators should be replaced if you find they are not working properly. Never use a
defective device.
3） Inductor Plate
- The wiper will get worn out due to sliding contact with a drum. Considering natural degradation, replace it
every six years.
- The gasket used for the connection between the pump and inductor plate will get worn out by repetitive
mounting and removal of the inductor plate. Replace it with a new one when it is damaged at the time of
inductor plate removal.

4.4 Design standard use period

Design standard use period is established for the product. (See the table below.)
Use of the product beyond this period may result in personal injury or property damage.
- Pump...Refer to "Instruction Manual for APP067U".
- Lift and inductor plate...10years
Application
Season
Temperature
Material being pumped
Container
Operating pressure for lift
Daily Amount of Material being pumped
Operating Days per year
Standard Conditions of Use for Lift and Inductor Plate
JIS Z 1600 Open Head Steel Drums, Drum type D (208L)
Pumping and transferring grease
Spring and Fall
20°C
Lithium Soap Grease: No.1
0.4MPa
1 drum
260 days (5 days a week)
12