Table of Contents
Advertisement
Warnings/Cautions
Carefully read the label attached
to the panel before use.
Lift air regulator
"AIR" button
(for inductor plate)
"PRESS" button
(for lift)
1.2 Contents of package
The unit is packed in a wooden box.
Please make sure no damage during shipment and no missing accessories after unpacking as soon as possible.
Please make sure no loose screws, piping connections, and fastener components.
Please retighten if any screws, piping connections, and fastener components are loose.
2. Installation
- This unit rises up to a full height of 2503mm. Be sure to have enough space around the unit when
installing.
- Be sure to turn each air regulator all the way to the left (counterclockwise) BEFORE connecting
hoses.
- Apply sealing compound or sealing tapes to the male screws and tighten tightly when the pipes are
connected.
Be careful not to allow the sealing materials to enter the piping.
Do not apply the tip of the terminal (two thread ridges) to maintain conductive property of the
ground.
(However, no applying is necessary if it will be connected to the hose union.)
Check that there is no leakage or electrical continuity in each part after connecting the piping.
- Keep yourself away from the lift when operating it. Do not touch any part of the unit other than the
switches on the operation panel.
- Do not put your hand or any other parts of your body between a drum and the inductor plate when
installing a drum. An unexpected body injury may be caused.
Fig. 2 Part names of operation panel
CAUTION
2
Air valve for pump
Pump air regulator
Lift control switch
(DOWN-STOP-UP)
Advertisement
Table of Contents
