Tilkobling Av Batteri - Connecting Of The Battery; Jording - Earthing - Generac Power Systems TOWER LIGHT V20 Owner's Manual

8,5m 4x320w led
Hide thumbs Also See for TOWER LIGHT V20:
Table of Contents

Advertisement

V20 8,5m 4x320W LED
Den elektriske forbindelsen mellom lyskasterne
og kontrollpanelet til lystårnet er en spiralkabel,
satt på en sylinder som muliggjør funksjonell
glidning. Ved ekstreme værforhold kontroller at
spiralkabelen fremdeles glir i sylinderen.

13.3 TILKOBLING AV BATTERI - CONNECTING OF THE BATTERY

Maskinen leveres med batterikobling frakoblet.
Koble til batteribryteren (37).
13.4 JORDING – EARTHING
Jordingssystemet må installeres i samsvar med
gjeldende lovgivning på bruksstedet. Det er
brukerens ansvar å bestemme kravene og/eller
bruk av den lokale eller nasjonale koden som
regulerer jordingssystemet.
Jordingssystemet
utføres
av kvalifisert
forskrifter.
Hvis
nødvendig
hovedjordklemme (22).
Jordkoblingen må, hvis nødvendig, utføres ved
å bruke en kobber-kabel med minimum
diameter på 6 mm².
Produsenten kan ikke gjøres ansvarlig for
eventuelle skader som følge av feilaktig
jording.
KUBOTA ENGINE
kontrolleres
og/eller
person,
iht.
lokale
koble
enheten
til
The
electrical
floodlights and the command panel of the
lighting tower is ensured by means of a turn
cable placed into a cylindric folder that allows
a comfortable sliding. In case of extreme
environmental condition, check that the turn
cable sliding into the cylindric folder is still
allowed.
The machine is supplied with the battery
connected at battery switch disconnect.
Connect the battery switch (37).
Earthing arrangement shall be carry out
accordingly to site current regulations. It is
user's
responsibility
requirements and/or applicability of local or
national code which governs earthing practice.
Earthing
arrangement
supervise and/or carried out by skilled
personnel, according to local regulations.
If required, connect the unit to the true earth,
through the MET (Main Earth Terminal) (22).
Connection to true earth, if needed, shall be
made by means of a copper cable with a
minimum cross-section of 6 mm².
The manufacturer is not responsible for
any damage caused by failure of the
earthing.
39
connection
between
to
determinate
setup
shall
TL193-18-09-00
17-09-2018
Norsk - English
the
the
be

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents