Table of Contents
Advertisement
I
NSTALLING THE
2
This chapter describes how to install your
®
SuperStack
II Switch 3900 on a table top, in a
free-standing stack with other SuperStack II products,
or in a distribution rack.
See Appendix B for site requirements.
To install the Switch 3900 system on a table top or
in a free-standing stack, read these sections:
"Before You Begin" (the next section)
"Installing the System on a Table Top or in a
Free-Standing Stack" on page 2-2
To install the Switch 3900 system in a distribution
rack, read these sections:
"Before You Begin" (the next section)
"Installing the System in a Distribution Rack" on
page 2-3
S
YSTEM
Before You Begin
Before you begin this procedure, be sure to:
Move the Switch 3900 system close to where you
plan to install it.
Install the system near an easily accessible power
outlet. You can power down the system only by
removing the power cord from the power source.
Have a No. 1 Phillips screwdriver available.
Have the system mounting kit available. See
Table 2-1.
Table 2-1 Switch 3900 System Mounting Kit
Qty Item
4
2
6
To use in
Rubber feet
Stacking the system on a
(self-adhesive)
table or in a stack
Mounting brackets
Installing the system in a
distribution rack
M4 x 10 pan-head
Installing the distribution rack
screws
brackets
Advertisement
Table of Contents
