Communication; Maintenance / Service; Peripheral Devices; Restore Factory Settings - Siemens Synco 900 Mounting And Commissioning

Communication

Protocol
Konnex (RF and / or wire-bound)
KNX TP1 2-wire bus conforming to KNX TP1,
plus RJ45 jack for connection of service tool
KNX RF RF bus conforming to KNX RF

Maintenance / service

Peripheral devices

Restore factory settings

To restore the factory settings of the peripheral devices, press the
multifunction button on the device for at least 20 seconds.
Then, a restart is made. Now, the factory settings are restored and
the device is no longer connected to the central apartment unit.

Manual control of the radiator control actuator

For service work, or in the event
of fault, the SSA955 can be
brought into any position using a
3 mm hexagon socket wrench.

Disposal

The central apartment unit and the various partner devices
must be disposed of as electronic scrap in compliance with
the European directive 2002/96/EEC (WEEE), and not to-
gether with municipal waste. The relevant national regulations
must be observed using the correct disposal channels. Local
and currently valid legislation must be complied with. Ex-
hausted batteries must be disposed of in compliance with the
relevant environmental regulations.
80/88
Siemens
Building Technologies
Synco 900
Communication
3 mm
-
+
-
+
CE1C2707en
05.07.2007