Elation Fuze SFX User Manual page 16

G O B O I N S T A L L A T I O N
7. Locate the rotating gobo that will be replaced. Grip the edges of the geared gobo
holder and gently lift (pictured at left) until the gobo holder clears the surface of the
gobo wheel. Then pull the gobo holder out and away (pictured at right).
8. Place the gobo holder on a flat, level surface with the geared side down. Locate the
tab of the spring, and use a precision pick (or similar tool) to push the spring tab
inward. Remove the retaining spring and carefully separate the gobo from the gobo
holder. Exercise caution to avoid scratching the gobo.
9. Install the new gobo and reassemble the fixture by following the steps above in
reverse order.
GOBO INSTALLATION COMPLETE!
16