Elation Fuze SFX User Manual page 14

G O B O I N S T A L L A T I O N
3. Optional. This step may be performed to help improve access to the gobo wheel
module. On the prism module, find the 4-pin connector (denoted by the yellow box,
above right) in the that is located behind the left-most electric motor, just beside the
thumb screw on the left hand side of the prism module. Disconnect this connector.
4. Optional. This step may be performed to help improve access to the gobo wheel
module. Loosen the thumb screws for the prism module, and carefully slide the prism
module out of its mounting slots. Set the prism module aside for later reinstallation.
14