FUTABA T12Z Software Update page 3

Channel Mode Selection
When using the TM-14 RF module with the T12Z,
there are two modes
multi-channel mode (as utilized in conjunction with the
R6014FS receiver) and 7-channel mode (used for
receivers such as the R617FS). It is important to set
the channel mode selection to match the receiver being
utilized in the model. Please refer to the chart below
as a reference guide.
Transmitter
TM-14 Multi-ch mode
Module
7ch mode Compatible
1. Access the frequency setting [FREQUENCY] in
the linkage menu and then press the DATA
button. The currently selected transmission
mode is displayed.
2. To change the mode selection, select the alternate
transmission mode.
[FASST MULT] : Multi channel mode
[FASST 7CH] : 7 channels mode
3. Press the DATA button, the display will return to
the confirmation screen.
A channel relocation screen will appear. If you
4.
wish to relocate the channel assignments,
select the [Yes]. If not, select [No]. The channel
assignments will not be modified.
of operation available:
Receiver
R606FS R607FS
R616FFM R617FS
— —
Compatible
(Information pertaining to the 7 channel mode)
When the 7 channel mode is selected, the following
conditions are applicable:
While the setting items of channels 8 and above
may appear in the various menu options (e.g., sub
trims, servo reverse, etc.), the only settings which
are applicable are those of channels 1-7.
When using the 7 channel mode, fail safe is only
R608FS
available for channel three (throttle). If/when the
R6014FS
fail safe for channel three has been activated, the
Compatible
battery fail safe is also active. Unlike the multi
—
channel mode, the fail safe and the battery fail
safe can not be set independently.
Channel Assignment
Servo connection
Below is a reference chart which has been created to
obtain the optimum performance from the FASST
system in conjunction with the channel mode and
various swash types.
adhere to this reference information in order to achieve
the maximum performance from the model. As such,
please connect the servos to the corresponding
channels in the chart below.
CH
1
2
3
4
5
6
7
8
9
10
11
12
VC1
VC2
VC3
VC4
It is important to note that these settings differ
from that used in the previous G3 receivers.
Utilizing the channel assignments from the G3
receivers will not allow you to obtain the ideal
performance from your model.
Please note that the settings in the chart above
are the default settings.
data is reset, the channel assignments above
will be utilized.
- 3 -
It is important to note and
Multi channel mode 7 channels mode
Except Except
H-4, H4X
H-4, H4X H-4, H4X
Aileron Aileron Aileron
Elevator Elevator Elevator
Pitch Pitch Throttle
Rudder Elevator2 Pitch
Gyro Rudder Gyro
Throttle Throttle Rudder
Governor Gyro Governor
Governor Governor AUX5
Needle Governor AUX4
AUX3 Needle AUX3
AUX2 AUX2 AUX2
AUX1 AUX1 AUX1
AUX1 AUX1 AUX1
AUX1 AUX1 AUX1
AUX1 AUX1 AUX1
AUX1 AUX1 AUX1
As such, when the
H-4, H4X
Aileron
Elevator
Throttle
Pitch
Gyro
Rudder
Elevator2
AUX5
AUX4
AUX3
AUX2
AUX1
AUX1
AUX1
AUX1
AUX1