Adjust Motion Control Handle Position - Exmark STARIS E Series Operator's Manual

1. Lower nut
2. Upper nut
5. Shut off unit.
6. Remove the jack stands.
7. Check that the machine does not creep in neutral
with the park brakes disengaged.
Adjust Motion Control
Handle Position
If the motion control levers do not align horizontally,
adjust one or both levers.
Note: Adjust the horizontal alignment before the
front to back alignment.
1. Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2. Push the right motion control lever down out of
the PTO disengage position.
3. Check if the right motion control lever aligns
horizontally with the left motion control lever.
Figure 29
3. Links
1. LH Motion control lever
g267312
2. RH Motion control lever
3. RH Motion control lever in PTO disengage position
4. Check the horizontal alignment here
4. To adjust the right motion control lever
horizontally, the cam needs to be adjusted.
5. Release the cushion from the rear of the machine.
6. Loosen the nut holding the cam (see Figure 31).
1. Cam nut
7. Adjust the cam until it aligns with the left motion
control lever and tighten the nut for the cam.
Note: Moving the flat portion of the cam
clockwise lowers the handle, while moving it
counterclockwise raises the handle
Important: Make sure the flat portion of the
cam does not go above a vertical position
(right or left), or damage may occur to the
switch.
8. Tighten the switch screws.
41
Maintenance
Figure 30
Figure 31
g012878
g267325