Specifications; Systems - Exmark STARIS E Series Operator's Manual

Specifications

Systems

Engine
• Engine Specifications: See your Engine Owner's
Manual
• Engine Oil Type: Exmark 10W-50 Premium
Engine Oil
• RPM: Full Speed: 3600 ±50 RPM (No Load)
Fuel System
• Capacity: 5.0 gal. (19 L)
• Fuel Recommendations:
– For best results, use only clean, fresh, unleaded
gasoline with an octane rating of 87 or higher
((R+M)/2 rating method).
– Oxygenated fuel with up to 10% ethanol or
15% MTBE by volume is acceptable.
– Do Not use ethanol blends of gasoline (such
as E15 or E85) with more than 10% ethanol
by volume. Performance problems and/or
engine damage may result which may not be
covered under warranty.
– Do Not use gasoline containing methanol.
– Do Not store fuel either in the fuel tank or
fuel containers over the winter unless a fuel
stabilizer is used.
– Do Not add oil to gasoline.
• Fuel Filter: Replaceable In-line
• Fuel Shut-Off Valve: 1/4 turn
Electrical System
• Charging System: Flywheel Alternator
• Charging Capacity: Kawasaki: 15 amps
• Battery Type: Exmark 12V Non-Spillable, AGM,
Maintenance Free Battery Part No. 135-4421
• Battery Voltage: 12 Volt
• Polarity: Negative Ground
• Fuses:
– 20 amp charging system fuse
– 15 amp accessory fuse
Safety Interlock System
• LCD indicators appear for the park brake, drive
levers, and operator presence in the message
display on the front control panel.
Note: Because the PTO must be disengaged to
start the engine, the LCD indicator will illuminate
at this time.
• PTO must be disengaged and motion control
levers in neutral to start engine. (It is not
necessary for the operator to be on the platform
to start the engine.)
• Mower blades will stop if both motion control
levers are moved or released into the neutral
position.
• Engine will stop if the motion control levers are
moved from the neutral position with the park
brake engaged.
• The Operator presence and neutral LCD
indicators will not appear at the same time.
When the levers are out in the neutral position,
the neutral LCD indicator will appear, but the
Operator Presence will not. When either lever
is moved inward from the neutral position, the
neutral LCD indicator will disappear and the
Operator Presence indicator will appear.
Operator Controls
Steering Control: Fingertip drive control levers
provide independent speed control, braking and
neutral to each drive wheel for moving forward or
reverse, stopping, and power turning.
Transmission
• Two Hydro Gear variable displacement high
efficiency pumps independently coupled to two
high efficiency Parker/Ross wheel drive motors.
• Hydraulic Oil: Use Exmark Premium Hydro Oil.
• Hydraulic Oil Capacity: 2.4 qt. (2.2 L)
• Hydraulic Filter is replaceable cartridge type.
P/N 109-4180: 25 microns, 10 psi bypass
(Summer use above 32°F (0°C))
P/N 1-523541: 40 microns, 18 psi bypass (Winter
use below 32°F (0°C))
• Speeds:
– 0-7.5 mph (12 km/hr) forward.
11
Specifications