Floppy Disk Cannot Be Read Or Written Onto; Time And/Or Date Are Incorrect; System Fails To Boot; Error Messages On The Monitor - Fujitsu PRIMERGY RX100 Operating Manual

Floppy Disk Cannot be Read or Written onto

Mouse controller disabled
The mouse controller on the system board must be enabled if you use the
supplied mouse.
Ê Check in the Setup Utility D1483 that the mouse controller is Enabled.
6.7 Floppy Disk Cannot be Read or Written
onto
Ê Check whether the write protection of the floppy disk is activated.
Ê Check the entry for the floppy disk drive in the Setup Utility D1483.
Ê Check in the Setup Utility 1483 whether the floppy disk drive controller and
write permission are enabled (see technical manual for system board at the
PRIMERGY ServerBooks-CD).
6.8

Time and/or Date are Incorrect

Ê Set the time and/or date in the operating system or in the Setup Utility D1483.
I
If the time and date are repeatedly wrong when you switch on your
server, you must change the lithium battery. Contact our Service group.
6.9

System Fails to Boot

The system will not boot after installing a new hard disk drive.
Ê Reboot the System with the ServerStart CD or with a boot diskette and recon-
figure the server (see section "Configuring the Server" on page 48).
6.10

Error Messages on the Monitor

The meanings of the error messages are explained in the manual for Setup
Utility D1483 and in the documentation for the relevant components and
programmes on the PRIMERGY ServerBooks CD.
54
Problem Solutions and Tips
A26361-K875-Z102-3-7619