Table of Contents
Advertisement
Hardware Installation
Figure 8: Mounting the telescopic rail
Ê Place the prepared telescopic rails at the marked attachment points on the
support uprights. The fitting bracket (1) is located between the telescopic rail
(2) and the support upright (3).
Please note that the guide nubs of the fitting bracket must fit into a hole in
the support upright next to the spring nut.
Ê Secure the two telescopic rails in the rack at the left and right support
uprights (4).
Ê Mount the server (see section "Mounting/Removing the Server" on page 35).
A26361-K875-Z102-3-7619
Installing/Removing the Server into the Rack
33
Advertisement
Table of Contents
