Registering Your Extra Handset With Your Onis Base Station - Philips TD6816/BB051P User Manual

Registering your extra handset with your
Onis base station
To register your extra handset with your base station, proceed as
follows:
1
Unplug the power cable of the base station, then plug it
in again.
The base station beeps to indicate that it is now in
registration mode.
It is also possible to set the base station to registration mode using a
handset that has already been registered. Instead of step 1 above,
proceed as follows:
1. Press
2.
Press
3.
Enter the registration code (this is given on a sticker labelled "RC"
under the base station). Press
Your handset beeps to indicate that the base station is now in
registration mode.
2
Move the handset to be registered close to the base
station and press
mode.
3
Press
4
Press
CODE?
5
Enter the registration code (this is given on a sticker
labelled "RC" under the base station). Press
The handset will search for a base station that is in
registration mode.
After a few seconds, the handset beeps and
is displayed. In this case go to the next step.
If the handset cannot find a base station,
displayed, and you will need to try again.
6
Press
10
R
, then press
-
ADD HS
until
+
to display
- REGISTER
until
is displayed.
R
to leave menu mode.
Installing your extra handset
+
SETUP
to display
is displayed. Press
o
.
R
on the handset to enter menu
SETUP
, then press
is displayed, then press
o
. Press .
o
.
o
.
o
REGISTER
FAILED
will be
o
.
.